Cisco CCNA (200-301) practice questions
254 free questions with answers and explanations.
- 251.A network automation engineer is developing an Ansible playbook to configure VLANs on a group of Cisco IOS XE switches. The engineer wants to ensure that if a VLAN already exists with the desired configuration, Ansible does not attempt to re-apply the configuration, and if it doesn't exist, it creates it. Which Ansible module and state combination should be used to achieve this behavior?Automation and Programmability
- 252.A network technician is configuring an EtherChannel using LACP between two Cisco Catalyst 2960 switches. On SW1, the interfaces Gi0/1 and Gi0/2 are configured with 'channel-group 1 mode active'. On SW2, the interfaces Gi0/1 and Gi0/2 are configured with 'channel-group 1 mode passive'. What is the operational status of the EtherChannel?Network Access
- 253.An engineer has configured an EtherChannel using LACP between two Cisco Catalyst switches, SW1 and SW2. The configuration on SW1 for physical interfaces Gi0/1 and Gi0/2 includes 'channel-group 1 mode active'. The configuration on SW2 for physical interfaces Gi0/1 and Gi0/2 includes 'channel-group 1 mode passive'. However, the EtherChannel is not operational. Which of the following commands on SW1 would provide the most relevant information to troubleshoot the LACP status?Network Access
- 254.A network engineer is troubleshooting a connectivity issue between two switches, SW1 and SW2, connected via a single Ethernet cable. SW1's Gi0/1 is configured as 'switchport mode dynamic desirable', and SW2's Gi0/1 is configured as 'switchport mode dynamic auto'. What will be the operational status of the link between SW1 and SW2?Network Access